American Blade Works Slip Joint - Frag Milled Titanium Handle - Stonewashed Wharncliffe MagnaCut Blade

MagnaCut Slipjoint with Frag Milled Titanium

The frag milled variant is where the American Blade Works slipjoint leans modern, a segmented, hard-lined milling pattern straight off the contemporary EDC bench, machined into a folder whose bones are pure tradition. It's the one for the buyer whose other knives wear pocket clips. The whole family gets the deep-dive treatment in our American Blade Works slip joint review.

Blade

Hollow ground from 0.125 inch CPM MagnaCut stock and stonewashed, the 2.25 inch wharncliffe is thin where it cuts and strong where it matters. The straight edge delivers every ounce of pressure to a single line, and the reinforced tip takes the prying-adjacent abuse small knives always end up doing. MagnaCut is the steel Crucible built to end the compromise, edge retention, toughness, and true stainless behavior in one alloy, which is why it has taken over the American custom and mid-tech world.

Slipjoint Action

A tuned backspring holds the blade under tension with a half-stop at 90 degrees, parking the edge safely upright on the way open and the way closed, the mark of a maker sweating the traditional details. Phosphor bronze washers carry the pivot for a glassy action that snaps home with authority. No lock means no lockup to wear, and a knife that travels where locking folders are unwelcome.

Handle

The frag milling breaks the titanium scales into raised segments your grip locks into, wet hands, gloves, cold mornings, it doesn't care. Underneath the pattern is the same corrosion-proof titanium keeping the knife at 2.36 ounces, lighter than most traditional folders with a fraction of the build quality.

Carry

Clipless at 3.312 inches closed, it pockets the traditional way, or rides secure in the Lancelot Leather clip slip, the leather pocket sheath with a clip built to hold this knife. Knife and materials are 100% American made.

Shop all American Blade Works